Completed : Hasegawa 1/72 Northrop Grumman VF-0D Phoenix
Kit InfoBrand : Hasegawa 65718Scale : 1/72Media : StyreneMarkings : Kit The SubjectThe VF-0 is a development variable fighter pressed into service during the Mayan conflict in 2008 (as depicted in the OAV Macross Zero). Introduced in 2004, it is a trial production and testbed using Overtechnology for future variable fighters like...
WIP : Hasegawa 1/72 VF-0D Pt.3 – Painting & Finishing
I’m attempting another approach to painting this time so I’m skipping the black base + marble coat approach. This begins with a base coat Tamiya Gray Finishing Surfacer. The white areas were spots that I had to go back in to fix again. For the color scheme, I’m going with the 3-tone camouflage used by …...
A look at Rocket Punch in 2021
I finished 11 kits (again) for 2021! I was one short of my target even though the Covid-19 pandemic was still ongoing and I was home a lot more. I also didn’t have a ‘shitty’ build this year which would have eaten up a lot of time so I’m not quite sure why I slowed …...
Completed : Wave 1/20 SAFS
Number 11 of 2021...
WIP : Wave 1/20 SAFS – Construction & Finishing
I found another Shelf Queen which was quite near to the painting stages so what better time than do roll up the sleeves and finish it? Most of the gap filling had already been done although I spotted more things that I needed to fix. The Wave kits use polycaps for attaching the limbs so …...
Completed : Trumpeter 1/72 North American F-100F Super Sabre ‘Wild Weasel I’
Number 10 of 2021...
WIP : Hobbyboss 1/72 F-100F Super Sabre Pt.2 – Painting & Finishing
I decided to order a spare canopy direct from Trumpeter and received it after about 1.5 months. It still has the same fitting issues as the old one but at least it’s not cracked. In any case, I can finally start painting the kit. I began with a base of black. Then I added a …...
WIP : Hasegawa 1/72 VF-0D Pt.2 – Construction
I’ve always used round brass rods to mount my kits because the holes are much easier to drill out. However, the kit can spin in place with a round rod if I don’t use some sort of glue to secure it in place. I’ve previously used a polycap but the clutch eventually wore out and …...
Completed : Academy 1/72 Boeing AH-64E Apache Guardian ‘TNI-AD’
Kit InfoBrand: Academy 12514Scale: 1/72Media: StyreneMarkings: CJM AH-64E Apache Guardian + Kit stencils The SubjectThe Boeing AH-64 Apache is an American twin-turboshaft attack helicopter for a crew of two. It is armed with a 30mm M230 chain gun carried under the forward fuselage and has four hadpoints on stub-wing pylons for more...
WIP : Hasegawa 1/72 VF-0D Pt.1 – Construction
This will be an OOB build of the twin-seater version of the VF-0 Phoenix from Macross Zero. With its delta wings, I’ve always gotten the Dassault Mirage 2000 vibes from the VF-0D so I’ve also always planned to give the kit the same color scheme as the Mirage 2000D. But while playing around with the …...
